Chemists develop method to take ‘chemical fingerprint’ from gin samples

It is hoped it will help producers with quality control and allow regulators to detect fraudulent products.
Researchers have used nuclear magnetic resonance spectroscopy to exam gin samples in a trial which which could help producers futureproof their gins (Andrew Milligan/PA)
PA Archive
Ryan McDougall5 February 2024

Chemists have trialled a new technique that takes a “chemical fingerprint” of gin in seconds, which could help producers futureproof their gins and conduct quality control.

A team of researchers from Heriot-Watt University worked alongside the University of Edinburgh on the project, and say their findings could help alcohol regulators detect fraudulent products.

The Heriot-Watt team consists of Drs Ruaraidh McIntosh and Dave Ellis and PhD student Kacper Krakowiak.

The trio worked alongside Professor Dusan Uhrin from the University of Edinburgh on the project.

The researchers used nuclear magnetic resonance (NMR) spectroscopy to exam the gin samples.

The technique is more commonly associated with finding the structural determination of molecules.

Dr McIntosh said: “Gin production has exploded in Scotland and the UK over the past 20 years, but compared to Scotch whisky it’s very loosely defined and regulated, and not well researched.

“Producers need to know more so that they can ensure they have years of sustainable, flavoursome gin ahead of them.

“And consumers and importers need to know that gin is genuine and the quality they’re expecting.”

Dr Ellis added: “We know from whisky research that chemical compounds have a huge impact on the flavour and sensory properties of a dram, even though they are in very low concentrations.

“Understanding which compounds are in a gin, and have an impact on flavour and mouth feel, could help distillers improve their gin, or guarantee uniformity of flavour.”

He added: “At the moment, most gin analysis is carried out using mass spectrometry. It’s effective and highly sensitive but does not provide a complete picture of the composition in a single experiment in the way that NMR can.

“NMR basically fingerprints the gin’s chemical compounds. It does this by detecting the signals given by the hydrogen atoms in each compound. These act as markers and enable identification.”

“In under five minutes, we end up with an overlay of all these fingerprints, providing a snapshot of the compounds present.”

We determined which compounds were present in each gin, and in which quantities

Dr Dave Ellis

The team put 16 different gins to the test, some they bought from the supermarket and some samples were provided by colleagues at Heriot-Watt’s International Centre for Brewing and Distilling (ICBD).

Dr Ellis said: “We determined which compounds were present in each gin, and in which quantities.

“NMR can distinguish between different structural forms of individual molecules, and there are many of these cases in gin.

“For example, the flavour compounds pinene and limonene have the same atomic makeup but have different structures and, critically, flavours.”

He added: “We tested some fruit gins and gin liqueurs. The NMR identified the different varieties of sugar present in the gin, which are introduced through flavour additives, and their quantity. This is important information for consumers.

“UK distillers rely on imported juniper berries for their gin, and climate change could affect their quality and availability.

“If their traditional supply dries up, will sourcing juniper berries from elsewhere change the flavour? That’s what we could determine with this technique.

“NMR has huge potential for the gin industry.”

Dr Ellis said the whisky market is “well regulated”, but says there is no equivalent for gin.

He said the EU imposes some bare requirements, but “essentially you can make anything, call it a gin and nobody will give you any trouble. It’s a bit like the Wild West.”

He added: “Colleagues at the Heriot-Watt International Centre for Brewing and Distilling have created a database of botanicals and this could be used as a basis of standardisation in the future, but we shouldn’t discourage innovation in gin production.

“We just need to try and find a way of reassuring consumers that the ‘gin’ that they are drinking really is gin.”

The researchers are expanding their studies to embrace many more types of so-called gin and other alcoholic beverages.

The findings are reported in the Journal of Brewing and Distilling.

Create a FREE account to continue reading

eros

Registration is a free and easy way to support our journalism.

Join our community where you can: comment on stories; sign up to newsletters; enter competitions and access content on our app.

Your email address

Must be at least 6 characters, include an upper and lower case character and a number

You must be at least 18 years old to create an account

* Required fields

Already have an account? SIGN IN

By clicking Create Account you confirm that your data has been entered correctly and you have read and agree to our Terms of use , Cookie policy and Privacy policy .

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Thank you for registering

Please refresh the page or navigate to another page on the site to be automatically logged in